RC Klub (Miskolc) Belépés


Nagy_FW190 216.jpg

Építés, Technológia


Oldalainkat 50 vendég böngészi
Tartalom találatai : 2063015
FrSky D8R-II Voltage Divider for electric aircraft PDF Nyomtatás E-mail
Írta: Magi István   
2011. augusztus 26. péntek, 16:49

New dual-voltage divider, which supports the new and old D8R, D8R V2, D8R-II and D8R-II Plus FrSky receivers.

The device is available in two versions:

- Asymmetric divider of electric aircraft,
- Symmetric divider of Glow and Gas aircraft.

This is the asymmetric version (for electric aircraft):

A1 is 1/4 divider, max. 13.2V to input voltege. The A2 1/11 divider, max. 36.3V to input voltage. This corresponds to the old division ratio D8R V2 receiver + Flytron display configuration.

Ideal for electric aircraft (measurement LiPo and BEC)!

Old receivers D8R V2, the middle row to be removed from pods (these can be found in the factory's internal division of the A1).

If the serial port is required, then a third pods build insert it.

Sample application:
(for electricity airplane)

A1 measures the voltage of the system.
A2 measures the voltage of akku (LiPo).

The negatives get through the ESC.

The voltage divider used display Flytron and Turnigy 9x - er9x FrSky radios are also.

Calibrated setting Turnigy9x - er9x FrSky software:

Listen to the lowercase and uppercase V set (2 × auxiliary divider on / off)!

FrSky LCD display (setup):

The A1 channel receiver should measure the voltage, the A2 channel is used to measure voltage LiPo batteries.

Contact: e-mail

If you are using glow and gas engines, choose the symmetrical division version!